Digiop BLK-IPD104 Manuel d'utilisateur télécharger pdf (Page 12)

www.digiop.com

SECTION 2: INSTALLATION AND SETUP

2. Route the wire end of the power extension cable into the camera and connect it to the 12 VDC power connector.

3. Connect the other end of the power extension cable to the DC12V power adapter. The polarity of the adapter connector is

shown in the following diagram. DO NOT apply power to the camera at this time.

CAUTION



When applying power to the camera, ensure that the polarity is correct. An incorrect connection may cause a malfunction and

can damage the camera.

2.5 Install IPAdmin Tool

The IPAdmin Tool, included on the CD mini disk, is a utility that will discover cameras installed on your network and enable you

to perform the initial network setup for each camera. After a camera is setup on the network, the Microsoft Internet Explorer

web browser can be used to see video from the camera, set the camera’s password, date and time, nalize camera hardware

adjustments, and congure the camera for functional requirements.

The IPAdminTool can be loaded on a Microsoft Windows XP, Vista or Windows 7 operating system (32- or 64-bit). To use this utility

for the initial setup of your camera, your computer must be connected to the same network subnet as your camera.

At a computer on the same LAN (subnet) where your cameras will be installed, do the following:

1. Insert the CD mini disk provided with your camera into your computer’s CD ROM drive and open the CD in a Windows

Explorer window.

2. Find the IPAdminTool directory on the CD.

3. Copy the IPAdminTool directory with its contents to your computer hard drive.

2.6 Congure the camera network settings

Devices attached to a Local Area Network (LAN) are each assigned a unique address (IP address) that they use when sending

messages with each other. No two devices on a single Ethernet network can have the same IP address. Otherwise, addressing

conicts will occur.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Pas de commentaire

Digiop BLK-IPD104 Manuel d'utilisateur Page 12